aligned in My Home& Garden

How do you align doors on MFI bedroom furniture? Bought some bedroom furniture. Everything has gone up smoothly but I need to correct the doors. Anyone got any good tips? ... (Asked by stevenewman1)
View Entire Question \| Report Abuse \| Similar Questions \| See it in Y!
A.
dont bother they usually fall off anyway ha ha...(Answered by phm)

View Entire Answer \| Report Abuse \| See it in Y!

How do you use brick to cap a block wall? I have a 8 inch wide block wall that I would like to cap with standard brick. I am concerned about aligning the brick properly so that it doesn't hang over more on one side than the other. ... (Asked by Layne F)
View Entire Question \| Report Abuse \| Similar Questions \| See it in Y!
A.
A brick is the same size as the block 7-5/8 if you lay the brick as a sailer (on edge to hide holes) so it should line up perfectly...(Answered by home improvement at its best)

View Entire Answer \| Report Abuse \| See it in Y!

sagging wooden fence? I just put up a new Ceder woodfen fence that Katrina blew down. The fence looks great. The problem Im having is the double gat doent always align. Its starting to Sag. Is there anything I can do to make this gate straight?? Thanks! ... (Asked by snipe k)
View Entire Question \| Report Abuse \| Similar Questions \| See it in Y!
A.
remove the hinges from the gate and drive a dowel into the hole where the screws were with a hammer. If you have to you can drill out the screw hole then drive in the dowel. re-align the gate and put the hinge screws back in in the new location where the dowels are...(Answered by aussie)

View Entire Answer \| Report Abuse \| See it in Y!

How do you to drill a 1/2" hole in a steel pipe that has a 1/16" thickness? Type of drill bit to use? How to align and guide without slipping off of the round pipe with the drill bit? ... (Asked by dhp10)
View Entire Question \| Report Abuse \| Similar Questions \| See it in Y!
A.
Drill press and carbide bit with oil. If you don't have acess to a drill press, take the pipe to your local hardware store, they will drill it for you rather cheaply....(Answered by BearDown)

View Entire Answer \| Report Abuse \| See it in Y!

aligning upvc front and rear doors? Both our front and rear upvc doors I am told need re-aligning adjusting to form a correct seal. Anyone got information on this or have in fact done this. Any help grateful. ... (Asked by leandrax_ceraph)
View Entire Question \| Report Abuse \| Similar Questions \| See it in Y!
A.
If you are have patience you can try it yourself. Look at the door, is the spacing around the door even? If the gap at the top is more narrow, the lower hinge need to be spaced away from the jamb and vise versa. It now gets more complex........ alignment of the hinge plate (nearer the pin or away from the pin) will control the door if it "drags" on the jamb when it opens or closes. Trial and error for a first timer. Quick fix for an experienced carpenter. Good Luck...(Answered by Doubting Thomas)

View Entire Answer \| Report Abuse \| See it in Y!

Note: We are not affiliated with Yahoo! Answers in any way. All the content is retrieved from Yahoo! Answers. We are not responsible for the content. For more information, please see the term of service. The above content was retrieved on September 23 2009 18:53:25.from Yahoo! Answers (Category Home > Home & Garden > Do It Yourself (DIY)). We are neither affiliated with the authors of this page nor responsible for its content. The data may have changed since that time. Click here to search real time questions/answers from Yahoo! Answers.